24/7 Sydney Emergency Sparky
0405 353 236
Power & LightingLED, Downlights & Fans

Lighting, Power Points & Ceiling Fans

LED downlight upgrades, architectural and outdoor lighting, extra power points, ceiling fans and dimmer circuits — installed neatly, tested, and certified to AS/NZS 3000 without cutting your ceiling to pieces.

  • Minimal Ceiling Damage
  • Dimmable LED Options
  • Same-Day Completion
Call 0405 353 236
Warm LED architectural lighting installed in a modern Sydney living roomRecent Sydney Install
Downlights from $89 per fitting, installedLifetime Workmanship
Why Lighting Work Goes Wrong

The Three Things People Regret Afterwards

Lighting is the job most often done cheaply and most often done twice. These are the decisions that decide which it is.

!

Halogen Downlights Still Running

Halogen fittings draw up to 50W each and run hot enough to be a documented ceiling fire risk against insulation. A modern LED does the same job at 7 to 12W and runs cool enough to sit safely under batts.

!

One Circuit Doing Too Much

Adding lights and points to a circuit that is already loaded is how a board starts nuisance-tripping. The fix is a load assessment first, and a new circuit where the numbers say so — not a bigger breaker.

!

Dimmers Fighting the Fittings

A trailing-edge dimmer on a driver that wants leading-edge gives flicker, buzz and a dead fitting inside a year. Matching the dimmer to the driver is a five-minute decision that either happens or does not.

What a Lighting Job Includes

From a single replacement fitting to a whole-house LED conversion, the standard is the same.

Warm track and pendant lighting installed by Hooked Up Electrical

Layout Set Out First

Fittings marked and checked against joists, beams and furniture before a single hole is cut, so the spacing is even and nothing lands on a rafter.

Load Assessed

Existing circuit load measured before anything is added, so a new run gets its own circuit rather than overloading a board that was already near its limit.

Insulation-Safe Fittings

IC-rated LED fittings where they sit under insulation, which is what the standard requires and what most retrofits quietly skip.

Cleaned Up Properly

Ceiling dust contained, offcuts removed, and the room vacuumed before we leave. Plaster patching included where a fitting has moved.

Lighting & Power Questions

The questions that come up on almost every lighting quote.

In most cases yes. Where the new fitting matches the existing cut-out, it is a direct swap with no patching. Where the LED is a different diameter we either use a converter plate or patch and paint the difference, which is quoted up front rather than discovered afterwards.

Planning Lighting or Extra Power?

Send through the room and roughly what you want, and we will come out and set the layout on site. Free quotes on installation work across Greater Sydney.

Talk it through: 0405 353 236
Available Now • 24/7 DispatchNSW Lic #456652C
Call 0405 353 236